System Design and Installation · Salt Lake County
System Design and Installation in Draper, UT
From Manual J load calculations through custom duct fabrication and equipment commissioning — the engineering backbone behind every EAS install. Locally served by Exclusive Air Systems — 45+ years engineering HVAC across the Wasatch Front.
Local Service in Draper
System Design and Installation — Engineered for Draper
Our home since 1981 — deep local expertise across the Draper corridor. Our Draper customers receive the full benefit of EAS's engineering-first approach to system design and installation.
From Manual J load calculations through custom duct fabrication and equipment commissioning — the engineering backbone behind every EAS install. Every Draper project is backed by proper load calculations, code-compliant installation, and our 45-year reputation for quality over volume.
Specialized Services Included
5 Services Under System Design and Installation
Custom HVAC System Design
Complete HVAC engineering — Manual J/S/D calculations, system layout, and equipment selection engineered to your building's actual envelope.
- Manual J/S/D
- Envelope-based sizing
- Engineered layout
Ductwork Design & Fabrication
Engineered supply and return duct design per Manual D, with custom-fabricated ductwork and fittings built to SMACNA standards.
- Manual D design
- Custom fabrication
- SMACNA compliant
Equipment Selection & Installation
Right-sized equipment selection matched to your load, then installed and commissioned for verified performance.
- Right-sized
- Properly installed
- Performance verified
Static Pressure Balancing & Commissioning
Air balance and static pressure verification at every register so the system delivers design CFM and holds setpoint.
- Air balance
- Static verified
- Setpoint confirmed
Commercial Exhaust & Make-Up Air Design
Balanced kitchen and process exhaust with make-up air systems engineered to prevent negative pressure and code violations.
- Grease hood design
- Make-up air
- Balanced ventilation
Why Draper Chooses EAS
- Locally based in Draper — fast response across Salt Lake County.
- State Licensed & Fully Insured HVAC Contractor (Utah)
- A+ BBB Rating · EPA Universal Refrigerant Certified
Trusted in Draper Since 1981
For over four decades, Exclusive Air Systems has delivered custom-home heating & cooling, licensed gas systems, and commercial HVAC construction to Draper — one Draper-based team, quality over volume, never swap-and-replace.
Technical Process
How We Engineer This Service
Manual J Load
We run an ACCA Manual J calculation from your actual envelope, glazing, orientation, and insulation — not square footage.
Engineered vs. Off-the-Shelf
Quality Over Volume
Engineered design beats rule-of-thumb every time — comfort and efficiency are designed in, not hoped for.
Typical Swap-and-Replace
EAS Engineered Approach
RecommendedLocal Climate & Environment
How Draper's Climate Shapes This Service
Draper Bench Altitude
Draper's bench elevation and rapid new-construction growth mean systems must be engineered for altitude and modern, tighter envelopes — not legacy sizing.
Canyon Wind Freeze
Draper's canyon winds drive wind-chill freeze events; heating systems need capacity and reliability for wind-driven cold.
Dry Heat Peak Sizing
Dry 100°F+ summers stress compressors; we size for design peak without oversizing for average days.
IAQ Built Into Design
Filtration and ventilation are engineered into the design, not bolted on after the install.
Frequently Asked Questions
Draper Questions
As a Draper-based contractor serving Salt Lake County, we respond quickly to Draper calls — often same-day for urgent no-heat or no-cool situations, especially during peak winter and summer demand.
Nearby Service Areas